Clean and Repair Your PC to Get It Working Fast Again

If your computer is an old one and it's becoming dirty at a corner or suffering from problems, it would be a great idea to clean it up and get it working properly and speedily. Using a computer with sluggish speed can be very annoying and inconvenient, hence doing some steps to restore it is necessary. Repairing computer problems entails time and effort but it's not entirely difficult if the problems are minor ones. Spend a couple of hours to assess the troubles of your computer and repair it in the best way possible.

First, you have to check which programs are still working and which ones are not. Turn on your computer and run some programs to check if your computer is still working properly. If it starts but doesn't display anything, try to use a different monitor if you have another one. However, if nothing is still displayed, your video card may be the problem. On the other hand, if you see an error message while starting the computer about its hard drive/disk controller, then you should change your hard drive with a new one. Other common problems are connected with your computer's motherboard, RAM or CPU.

Next, open the case by pulling off the thumbscrews located on the side panel. Pull out the panel door. Open the case's other side using the same method. You may observe that the screws are either thumbscrews or Phillips screws.

It may be very dusty due to long storage so you have to blow off the dust using an air duster. Unscrew the components from the case to remove them. You can also disconnect them from the motherboard if necessary. Cleaning a computer makes use of special cloth so it's important to use a microfiber cloth cautiously when wiping the components. Don't forget to discharge the static electricity before doing any of these activities, else you may end up being electrocuted.

You can then pull out parts which aren't working anymore, based on earlier assessment, and replace such parts. After the replacement process, put the parts back together and close the case carefully. The last step is installing a recent, clean Windows copy. Be sure that all significant files are backed up on your computer.

Computer Repair

Article Source